骏马弹簧 骏马弹簧

1
Installation of serpentine spring coupling

11-22

Installation of serpentine spring coupling

① Install the seal ring and half shaft sleeve Installation of shaft sleeve seal ring of serpentine spring coupling At the beginning, we must turn off the startup power supply, wipe the coupling and the two connected shafts, and then apply grease on the half coupling and the seal ring (see the figure, put the seal ring on the shaft first). The cold installed quick installed coupling does not need to be heated, and the interference fit needs to be heated for installation.

Precautions for use of coil spring coupling

11-22

Precautions for use of coil spring coupling

The coil spring coupling has good elasticity. The flexible effect of the spring can greatly reduce the vibration generated during operation. The service time of the serpentine spring coupling is related to its production data.

Some Features of Serpentine Spring Coupling

11-22

Some Features of Serpentine Spring Coupling

T10 series basic serpentine spring coupling features: it is a horizontally separated housing with serpentine spring, which can be replaced without moving the connecting equipment. The serpentine spring coupling is a metal elastic coupling with advanced structure. The utility model embeds the serpentine spring plate axially into the slots of the two half couplings to complete the connection between the prime mover and the working machine.

Definition and introduction of coupling spring

11-22

Definition and introduction of coupling spring

The coupling spring is also called serpentine spring. The raw materials used are mainly 60Si2MnA and 50CrVA data standards. The thickness can be 20 mm larger than Z1, and the width can be 30 mm larger than Z1. Serpentine tension springs are supplied in groups (one coil is one group, and each group is supplied to test the size of the customer's coil springs. One coil is one group: two coils are one group, four coils are one group, and six coils are one group). The torque scale of this product is 26-270000N · M, and the allowable relative radial displacement of the two half shafts is 0.5-3mm, the axial displacement is 4-20mm, and the angular displacement is 1 ° 15 '.

< 1 >